Conductivity is often expressed as a percentage of IACS, which is a comparison to the conductivity of pure annealed Copper wire (which is the reference standard of 100%). Conductivity is an important property of an EDM wire, since it determines how...
Brass wires start out as a continuously cast 20mm diameter rod. This rod is either cold rolled or cold drawn until it is approximately either a 6mm round or hex cross-section. The wire is then annealed and drawn through a series of dies until it is...
Brass wires start out as a continuously cast 20mm diameter rod. This rod is either cold rolled or cold drawn until it is approximately either a 6mm round or hex cross-section. The wire is then annealed and drawn through a series of dies until it is...
Before the final dispatch, we ensure that the products are in accordance to the pre-defined quality standards. For the attainment of the complete clients' credibility, we issue an invoice to them including all the relevant information regarding...
wire EDM innovation with the introduction of H.E.A.T, or High Energy Applied Technology, which is a new technology to provide fastest cutting rates and operating speeds available in wire EDM production. This high accuracy application is possible...
Solid Brass Wires are Used Extensively in Automobile Industries for Making Engine Parts. Our Company Being One of the Most Prestigious Brass Wires Manufacturers Always Strives to Give Its Clients the Best of Results. Round Brass Wire is also Used in...
Brass wires start out as a continuously cast 20mm diameter rod. This rod is either cold rolled or cold drawn until it is approximately either a 6mm round or hex cross-section. The wire is then annealed and drawn through a series of dies until it is...
Brass wires start out as a continuously cast 20mm diameter rod. This rod is either cold rolled or cold drawn until it is approximately either a 6mm round or hex cross-section. The wire is then annealed and drawn through a series of dies until it is...
For Buyer 
For Seller 
Help 
