Woodward’s EML100 electric actuator provides high accuracy, closed loop position control for steam and gas turbine valves. The actuator positions a steam or fuel valve that requires a linear operator with a stroke length between 13 and 38 mm (0.5 and 1.5 inches). This linear...
The PG-EG Actuator converts a given electrical input signal into a proportional hydraulic output shaft position, to control engine fuel flow. The actuator provides the muscle for Woodward analog and digital controls. The PG-EG Actuator is available...
DYNA 2000 and DYNA 2500 linear actuators provide precise positioning with a minimal number of moving parts. Many of the moving parts normally associated with electric actuators are eliminated, prolonging the mean time between failure. These DYNA...
Torque-Speed capabilities: : Total gear ratio is adjusted at factory to obtain the following combination of torque and speed:
Supply Voltage: : AC, Single Phase, 230V, 50Hz.
Feedback Potentiometer: : 135Ω standard matched to stroke angle of either 900, 1600 or 2700. (The maximum permitted power dissipation for feedback potentiometer is 1W for 900, 1.5W for 1600, and 2W for 2700 stroke angle).
Power Consumption: : 20 Watts.
Stroke: : Auxiliary Switch (Optional): 2.5A, 250V, 50Hz, NO or NC. (Operated at only one fixed point).
MOTOR DRIVEN Same as cat. no. PHY- 355, but driven by an electric motor working on 220-240 V mains, with a separate discharging sphere mounted on rod....
Benefits : Long-term reliability,Low maintenance (battery replacement only on applicable models),Low cost of ownership,Easy installation and configuration.
Versatile electric actuator designed for quarter-turn valve and damper applications and is available in both NEMA 44X and NEMA 44X7&9 configurations. Features Universal power input; accepts 115230AC, 24AC, 1224DC Universal control; onoff or modulating from the same package...
Electric actuators, IBL-1700 series are reversing proportional motors used to operate dampers or valves in Electric Modulating Circuits. Electric actuators are designed to meet the requirement of damper control, valve control applications where it is generally required to drive...
The L&K Actuator systems are used in beds and comprise of linear actuators of varied stroke lengths based on the requirement, paired with suitable controller and remote. With the help of these, the users can attain the most comfortable position...
All values for lamp current of 15 mA AC Typical Intensity 254nm @ 0.75" (mWcm2): 4400 Typical Intensity 365nm @ 0.75" (mWcm2): 145 Lamp Operative Voltage: 300 Lamp Body Temperature: 100 degrees C 53.8mm lighted length (2.12"), 117.3mm length, Quartz...
Possible to move the auto switch mounting position as desired Direct mounting Connection port position: Side ported and axial ported selectable (When a switch and angle adjuster are installed, side ported only.) Low pressure operation: 0.2 MPa...
We are manufacturing wide range of Valve automation system which includes single acting Pneumatic actuator, Double acting Pneumatic Actuator, Regulating actuator, Stainless steel actuator, 180 Degree actuator, Rotary actuar. Sunaina offers Actuators...
The PG-EG Actuator converts a given electrical input signal into a proportional hydraulic output shaft position, to control engine fuel flow. The actuator provides the muscle for Woodward analog and digital controls. The PG-EG Actuator is available...