13khz pwm dc motor controller dc 12v-40v 10a motors electric pump fan speed stepless control module it comes with reverse polarity protection this is 13khz pwm dc motor controller dc 12v-40v 10a motors electric pump fan speed stepless control...
description:- the l298n driver module, using st's l298n chip can directly drive two 3-30v dc motor, and provides a 5v output interface can 5v single-chip circuitry to supply, support 3.3vmcu control, you can easily control the dc motor speed and direction, you can also control...
Features : These are compatible with all arduino compatible shields and the arduino ide, It has a standard 6x1 avr isp header, It comes with an atmega328 with a pre-burnt arduino boot loader.
L293D Motor Driver Stepper Motor Driver Module L293D MOTOR DRIVER/STEPPER MOTOR DRIVER BOARD MODULE Details: High Quality PCB Driver Module Onboard Capacitive filter Controllable by 5V/3.3V For Driving DC Motor/ Stepper Motor Module can...
Purity : Onboard the EPM240T100C5N chip.EPROM chip configuration using EPCS4, the size of 8Kbit.Onboard 50M active patch crystal (Crystal Slaughter halfback).
Purity : 20 Digital I/O Pins,12 ADCs,16MHz Clock Speed,32 KB Flash Memory etc.
This is Leonardo Board, Arduino's first development board to use one microcontroller with built-in USB. Using the ATmega32U4 as its sole microcontroller allows it to be cheaper and simpler. Also, because the 32U4 is handling the USB directly, code libraries are available which...
Purity : 20 Digital I/O Pins,12 ADCs,16MHz Clock Speed etc.
This is Leonardo Board, Arduino's first development board to use one microcontroller with built-in USB. Using the ATmega32U4 as its sole microcontroller allows it to be cheaper and simpler. Also, because the 32U4 is handling the USB directly, code libraries are available which...
Purity : 256k Flash Memory,16Mhz Clock Speed,16 Analog Inputs etc.
The Arduino Mega is a microcontroller board based on the ATmega2560. It has 54 digital inputoutput pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a...