The Flame Rod for Gas Flames is planned to detect visible light emitted by oil flames. These are not appropriate for oil-fired furnaces with the refractory blaze. The resistor is planned and manufactured in fulfillment with set manufacturing standards using qualitative stuff....
Connections : The sensor is fitted with a 10-way MIL-SPEC connector. A 4, 10 or 25 meter, 6 twisted pair cable pre-assembled for connection to a waterproof junction box is available.
Material Penetration : Approximately 75-100mm dependent on material.
Body : Stainless Steel
Moisture Range : The Sensor Will Measure Up to Saturation of Material.
Supply Type : Manufacturer
Analogue Outputs : 2 Configurable 0-20mA or 4-20mA current loop source available for moisture and temperature. May also be converted to 0-10V DC.
Fixing : The Hydro-Mix is secured to a fixing plate by a clamp ring. This allows the height of the sensor to be adjusted if necessary.