Kallpam Trading

Nanpura, Surat, Gujarat

We offer Single Pack Silicone that is available under the popular Krisrepell Brand. Single Pack Silicone, offered by us, is water and oil repellent. Single Pack Silicone (KRISREPELL) is available in two grades. One grade is for a treatment of mineral substrates i.e. facades of air faced masonry and cement. Another grade is to improve oil and water resistance of hard stones, marbles, granites etc. Both the materials are ready to use chemically 'SILANE - SILOXANE' composition in a solvent media, forms a chemical structure similar to Quartz on application and reaction. The Cementitious - mineral building materials when comes in contact with water, pollutant gases and carbon dioxide, they absorb water and results into a damage. The damages are like penetration of moisture, cracks due to swelling & shrinkage, frost & deicing salts, efflorescence and salt damage caused by hydration and crystallization, lime leaching, rust stains, dirt pick up, attack by algae, fungi and moss & chemical corrosion of reinforcement steel yield to destruction of concrete.

Benefits

• Ready to use.
• Can be applied by brush, roller or spray.
• Very thin liquid - deep penetration.
• Drastic reduction in water absorption.
• Resistance to alkalies.
• No change in surface appearance - glossy, tacky or yellowing.
• Resistance to UV light.
• Bridges hairline crack for water repellency.
• Excellent water vapor diffusion.
• Non toxic - no health risk.
• Environmental friendly.
• Stops water seepage & leakage.
• No paint washout - protects paints.
• Prevents corrosion of reinforcement.
• Increases oil, water & stain resistance on absorbent minerals.

End UsesProtection of following substrates from water in exposed condition cement concrete, mineral plaster and paints, sandstone, sand lime bricks, limestone, marble, granite, brick, jodhpuri and jaipuri stones. KRISREPELL is ideal for water repellency of facades and sloppy roof terrace. Direction For Use Surface PreparationThe surface shall be free from oil, grease and dirt. The surface shall be clean and dirt free, otherwise dirt will get dissolved into solvent & will represent dirt stains. If possible wash the surface with clean water after thorough wire brushing. Allow the surface to dry for better penetration. The surface may be slightly damp but not wet. Application

• Apply two coats of KRISREPELL wet on wet by brush, roller or spray in a flooding way i.e. the material shall
• Run down the substrate while application. The maximum the penetration the best performance it will provide. The performance can be tested only after drying for 24 hours or after 3 days.

Cleaning Of Tools : Clean the tools by white spirit, kerosene or xylene solvent. Storage & Shelf Life : Shelf life is one year from the date of manufacture. Store the material in cool & dry place away from sun heat.

We are known for making available the quality Concrete Curing Compound. The different varieties of Concrete Curing Compound that we deal in are available under the brand Crete Cure. CRETE CURE W1 & W2 (Concrete Curing Compound) are economical wax emulsion based compound specially formulated to form highly efficient and low cost curing membrane. Concrete Curing Compound dries to a clear and white film which provides effective water retention and a dust free hard surface after application on fresh concrete it retains water, to ensure the strength development of the concrete. The Concrete curing Compound Clear And white being water based and nontoxic, fire hazards are eliminated. Degradation time of the compound membrane depends on weathering and traffic.

Benefits

• Nontoxic, nonhazardous.
• Easy to apply by brush, roller or spray.
• Economical concrete curing with high efficiency.
• Provide harder and dust free concrete surfaces.
• Specially designed for exterior concrete pavements and mass concrte construction.
• Ensures the strength development of the concrete.
• CRETE CURE W2 white provides solar reflective film.
• Degrades after complete curing of the concrete.

End Uses : Dams, Paving, Precast pipes, Exterior mass concretes. Specific Compliance

• CRETE CURE W1 - ASTM C 309 : 77 Type I, Class A
• CRETE CURE W2 - ASTM C 309 : 77 Type I, Class B

Direction To Use ApplicationCRETE CURE are suitable for application under high temperature conditions on exterior concrete pavements & mass concrete constructions but not recommended to use below 5 C Apply by spray or roller or by brush on newly placed concrete (horizontal) surfaces stcots disappearing. On vertical surfaces it is essential that the surface has to be dampened with clean water. Cleaning : Clean the equipments with water immediately after use. Packing : 35, 200 Liters plastic drum.