Write a Review
Our Products
We offer the best product range of Immersion Dip Coating and Lab And Pilot Scale Coating.
This is an industrial coating process; in which the substrate is dipped into a tank of the coating reservoir, which is normally of a low viscosity to enable the coating to run back into the bath as the substrate emerges. This process is frequently used on porous substrates. Immersion/Dip coating process take after the set method which takes after as parts to be covered ought to be cleaned to evacuate contaminants. This outcomes in unrivaled groundwork attachment and in addition enhanced consumption resistance. In the event that grip to the part is craved, use of a preliminary is needed on all areas were polymer coatings needed. The prepared part is streak dried and heated to set the preliminary and prepared the part for the hot dipping operation. The prepared part, hot from the groundwork change heat, is inundated in the fluid material. Every single hot piece of the product submerged in the fluid polymer will layer upon withdrawal from the shower with a layer of semi-combined polymers. The amount reserved will depend on the period of time the part was drenched, the metal temperature that the part was submerged at, and the general plan of the compound utilized. The higher the metal temperature and the more extended the immersion time, the more noteworthy the polymer thickness. The part covered with the semi-melded polymer is prepared to a temperature subordinate upon the particular compound equation. This finishes the combination of the coating, and grip to the product. At the point when the hot part covered with melded polymer leaves the stove, it is exceptionally touchy to surface damaging. The part is chilled off before handling. The completed covered product is then expelled from the transports, reviewed and readied for pressing and shipment.
Advantages
If you want to realize it before you release, if you are looking for small scale production system, if you are looking for coating solution for research or scientific laboratories, then we can be your dependable choice for your lab scale and pilot scale solution for coating lines. Our Lab scale and Pilot scale coating systems have proven their selves in all type of needs of the clients. Even several pilot scale coating systems are designed such a way that it can be accommodated easily without or with minor changes only. KERONEs Lab and Pilot scale coating systems are of plug and play type, sizing 10 inches to more than 50 inches. We produce lab-scale and pilot-scale coating systems to achieve same level of quality and efficiency as of production scale coating system. We design and manufacture lab and pilot scale coating with of various such as Gravure Coating, Knife coating, Curtain Coating, Knife-Over-Roll Coating, Web Coating and Mayer Rod Coating.
Lab scale and Pilot scale coating lines are ideal to get the chemistry of coating rightly in place by trying various coating combination with substrate, suitable for the small scale production, NPD (New product development), science labs. Machines are very elastic and adaptable.
Some of the feature of our produces system is:
KERONE (KERONE)
4/5, MARUDHAR INDUSTRIAL ESTATE, PANCHAL ROAD, OPP. SYNDICATE BANK, BHAYANDER (E), MUMBAI-401105. (INDIA), Maharashtra
Share us via
