The materials used for the manufacture of gears depends upon the strength and service conditions like wear, noise etc. The gears may be manufactured from metallic or non-metallic materials. The metallic gears with cut teeth are commercially...
Features : efficient power transfer and durability, carry heavy loads
Miter gears are bevel gears put together with equal numbers of teeth and axes that are usually at right angles. Miter is the surface forming the beveled end or edge of a piece where a miter joint is made. Miter gears are cut with a generated tooth form that has a localized...
• Upto 20 Module/1.5 D.P. • Outer Diameter Upto 2100mm/80" • Face Widths upto 800 mm/31" • In Single or multi starts • Center Distance from 25mm/1" to 500mm/20" • In Cast Iron, Bronze (PB2S), or as specified • Optionally available...
Helical Gears and Pinions • Upto 20 Module/1.5 D.P. • Outer Diameter Upto 1250 mm/50" in Helical gears and Pinions Face Widths upto 800 mm/31" • Required information for quotation: Material of Construction - steel, EN 8, EN 24, EN 353, SAE...
• Upto 20 Module/1.5 D.P. Outer Diameter Upto 2500 mm/100" in spur gear and Pinion Required information for quotation: Material of Construction - steel, EN 8, EN 24, EN 353, SAE 8620 etc Teeth Specification - pitch in Module or DP, Helix Angle...
A gnee manufacture custom precious Gear Rack and Pinion in both Spur and Helical tooth form in steel, stainless steel , cast iron , brass , bronze, plastic, hylam etc. Heat treatment facility is also offered. Continuous length of Gear Racks up to...
For Buyer 
For Seller 
Help 
Ask a question about 
