Other Products / Services #1268128

Flat belt training idlers automatically train the belt and protect the belt edges from damage caused by misalignment. Available in the positive action type for belt operating in one direction.Flat belt impact idlers protect the belt by absorbing impacts at transfer points.

Chevron Conveyor Belt have rubber profiles that are integrally vulcanized with the top cover of the belt. These profiles are made with highly abrasion resistant rubbertypes and are offered in Softer Compounds(45-50 Shore)as also 60 shore materials. The profiles are shaped in such a manner that there is no need for special idlers and these can be run on conventional conveyors. The pitch of the Chevron ensures a smooth ride over flat return Idlers.

We introduce ourselves as a leading manufaturer and exporters of conveyor, conveyor belts and timing pulleys. Used mainly all giant units of Cement, Chemicals, Pesticides, Ceramic, Power, Sugar, Textiles, Printing & Glass Industry.

Directions of use: Mix one botle of Hardener per litre of solution coat the surfaces with mixed solution. Allow to dry until tacky and then press together under maximum pressure and hammer thoroughly.Stir Well Before use. Two Coats for Normal Applications. Three Coats for Critical Applications.

Throughing idlers. generally used for conveying bulk materials. are available with side rollers inclined at 20 and 30. Idlers with 45 or other troughing angles can also be supplied in special cases.
Flat belt impact idlers protect the belt by absorbing impacts at transfer points.

Flat belt training idlers automatically train the belt and protect the belt edges from damage caused by misalignment. Available in the positive action type for belt operating in one direction.

Trough belt training idlers, also popularly known as self-aligning troughing idlers, automatically train the belt and protect belt edges from damage caused by misalignment. The standard types are available with 20 and 30' troughing

Troughed belt rubber cushion idlers which are also known as impact at loading point. They include 200 and 300 trough. However, idlers wiht 450 or other troughing angles can also be supplied.

Return belt idlers are used for supporting the return run of the belt. The standard type includes single roller with end brackets. However, inclined tworol1er type is also available for specific application.

Return belt rubber tread idlers are used when wet or sticky materials tend to cling to the belt where corrosion resistance is required or where chemical action to iron or steel is involved.


Roller BodyThe shell is made of precision smooth surface "ERW" steel tube as per IS: 9295.
Roller EndsBearing Housing made of pressed steel sheet with calibrated bearing seat, are welded with te periphery of the steel tube. for maximum strengths.

SpindleSpindless are made from M.S. bright bars and are precision ground at bearing and seal seating areas.

BearingPrecision single-raw deep grove ball bearings with C3 clearance are provided. Distance between bearing and point of support at the shaft is very short and thus ensure higher load carrying capacity and longer service life.

SealingThe double multi labyrinth seal ensures optimum protection against the entry of dust and dirt in to the bearing.
Inner Seal , Dust Cover , Rain Cap

Lubrication
Hi-lithium base grease is filled in measured quantities in bearing and seals and rollers are sealed for life.

Adjustability
Idler rollers are manufactured as per IS 8598 for Belt width as per IS 4776 as well as to suit existing conveyor frame by providing adapter.

Economy
Extremely light weight construction ensures less torque, imparting longer life to belt, motors, pulleys and driving arrangements. Extremely low friction factor ensures very low.