GST : 27AAPCM8700R1ZL
4.5/5
Our Products
We offer the best product range of High Voltage Breakdown Tester.
Every electrical apparatus or machine is provided with insulation between live part and earth or between two different sections of live parts. This insulation is required to be tested at high voltage values recommended by applicable relevant standards.
The standard Specification for various electrical apparatus specifies Power Frequency Voltage withstand test at different levels depending upon working voltage of electrical apparatus. It is observed from the various standards for electrical equipment’s that the minimum power frequency voltage withstand test level for electrical insulation is 2kV for one minute.
We have, therefore, standardized on manufacture of’ MARSZ High Voltage Breakdown Testers with rated voltage of 5kV.
High Voltage Tests Sets of higher voltage upto 600kV are also manufactured against specific requirement. The standard voltages are 10kV, 15kV, 20kV, 25kV, 30kV, 50kV, 100kV, 150kV, 200kV & 300kV. The test sets upto 30kV are manufactured in Air Cooled design while the sets of 50kV & above are manufactured in Oil Cooled design. The output of these high voltage testers is single phase 50/60Hz. The standard H.T. current rating of air-cooled design as also of oil cooled design upto 150kV is 100mA for 30 minutes. For voltages ranges above ‘MARSZ’ make 5kV A.C. (with 2.5kV tap) High Voltage Breakdown Tester is portable, sturdy & plug in to start type construction & requires minimum table space. It broadly consists of 3 main sections.
High Voltage Transformer:
The High voltage transformer is single phase, single pole type & is of double wound resin moulded construction. The H.T. winding is provided with graded insulation such that one end is insulated for 2kV insulation and is earthed through a current sensing transformer & mill ammeter whereas other end is insulated for full rated voltage & the same brought out through H.T. Cable & spring loaded Prod.
Variable Voltage Source:
Variable Voltage supply is provided through a “VARIVOLT” (Variable auto-transformer) having a suitable rating corresponding to the rating of H.V. Transformer.
Dimmerstat Is rated for 230Volts A.C. input & 0-270V output. Limit switch at zero position end of Dimmerstat winding is provided to facilitate the H.T. winding to
Control Circuit & Other Features:
Mr. Rahul R. Kulkarni (Marsz Electricals Pvt. Ltd.)
C-607, Balaji Tower / 30 Vashi, Opposite Sanpada Station, Navi Mumbai, Maharashtra - 400705, India
https://www.marszelectrical.in
Share us via
