Write a Review
Our Products
We are leaders in the market for providing best range of Communiting Mill, Colloid Mill, Flexible Shaft Grinder, Colloid Ointment Mill and Flexible Shaft Grinders
The Comminuting- mill is used in high speed size reduction, granulation, pulverization, mixing, shredding, etc. of wide range of dry and damp materials with out any special attachment.
Mill has been specifically designed for wet and dry granulation, pulverization or dispersion of products or ingredients found in the Pharmaceutical, Chemical and Food Industries.
Product fed in the hopper slides down to the enclosed chamber, where it is milled in between horizontal beaters and screen to the required mesh/micron size which can be collected at output container.
Knife edge is used for coarse or large particles and impact or flat edge for finer particles. High speed is used for grinding, low speed for coarser particles. A wide range of screens is available for various process needs.Quality and output depends upon the three main variables : Beaters shape (knife / impact forward) , Speed, Product / Particle size to be processed.
Optional :
Applications :
| Construction : |
| Am-colloid mill is driven by a special vertical type highspeed motor, which along with a 5S-housing provides working area of the mill. Circular shaped stator assembly having two different tooth stages, the conical rotor that is directly coupled, and shape of the rotor and stator permits to axially adjust the grinding gap to an accuracy of 0.10 mm. The opening or dosing of this gap is calibrated on a scale. One rotation of the adjusting ring corresponds to a grinding gap of 0.5 mm. Operation : In Am-colloid mill the product is subjected to high shearing cuffing, and rubbing forces between two toothed surfaces. The product, while passing down the hopper, inibally gets seized in the preliminary braking drum where it is broken and thrown into the first stator tooth stage. Due to conical arrangement and the centrifugal effect of the rotor rotating at a speed of 2800 RPM, the material is forced into second tooth stage. The tooth design of the grinding set causes powerful vibrations that subject the particle with high degree of forces. In turn particle reaches the lowest grinding stage. The ground material continuously leaves the mill through the outlet pipe, if required, it can be recirculated. |
Zahid Khan (Powertech Industrial Equipments)
501, AL REHAN, GLOBAL PARK, KAUSA MUMBRA THANE MAHARASHTRA INDIA, MUMBAI, Maharashtra - 421301
Share us via
