This Instrument Makes Accurate Measurements Of The Indentations For All Brinell Type Hardness Testers. Our Brinell Microscope Rbm-55 Is A Compact, Yet Durable Instrument, Making It Suitable For Both The Shop And Laboratory. The Reticle Is Calibrated In 0.01 Mm. Units Over A Range Of 6mm. And The Field Of View Is 7mm. Measure The Indentation At Its Largest Diameter Against The Reticle Scale. This Microscope Is Designed To Easily Measure The Brinell Hardness Value Of Different Ferrous And Non-Ferrous Metals Including Crude Or Annealed Steel (Non Austenitic Steel Only), Quenched And Tempered Steel (Non Austenitic Steel Only), Cast Iron, Brass Casting, Rolled Brass, Rolled Cooper, Alloy Of Tin And Bronze And Casting Of Aluminium Alloy.It Can Determine The Brinell Hardness By Measuring The Diameters Of The Indentations Left On The Test Piece And The Standard Hardness Test Block. The Indentations Are Obtained By The Steel Ball Of The Tester Located Between The Piece And Test Block With An Instant Load Applied By Hammer. The Brinell Value Can Be Obtained By Referring The Conversion Table After Measuring The Indentations By The Readout Microscope. Widely Used In Shop, Material Supplier, Plant And Quality Control Due To Lightweight, Easy Operation And Convenience.

This Instrument Makes Accurate Measurements Of The Indentations For All Brinell Type Hardness Testers. Our Brinell Microscope Rbm-55 Is A Compact, Yet Durable Instrument, Making It Suitable For Both The Shop And Laboratory. The Reticle Is Calibrated In 0.01 Mm. Units Over A Range Of 6mm. And The Field Of View Is 7mm. Measure The Indentation At Its Largest Diameter Against The Reticle Scale. This Microscope Is Designed To Easily Measure The Brinell Hardness Value Of Different Ferrous And Non-Ferrous Metals Including Crude Or Annealed Steel (Non Austenitic Steel Only), Quenched And Tempered Steel (Non Austenitic Steel Only), Cast Iron, Brass Casting, Rolled Brass, Rolled Cooper, Alloy Of Tin And Bronze And Casting Of Aluminium Alloy.It Can Determine The Brinell Hardness By Measuring The Diameters Of The Indentations Left On The Test Piece And The Standard Hardness Test Block. The Indentations Are Obtained By The Steel Ball Of The Tester Located Between The Piece And Test Block With An Instant Load Applied By Hammer. The Brinell Value Can Be Obtained By Referring The Conversion Table After Measuring The Indentations By The Readout Microscope. Widely Used In Shop, Material Supplier, Plant And Quality Control Due To Lightweight, Easy Operation And Convenience.