• To determine the hardness of any cylindrical element in Degree Shore.
• Very useful for spinning mills to measure the hardness of rollers used in Ring Frame, Draw Frame, Roving Frame etc.
• Latest design with modern stylish look.
• Handy, easy to operate
• Duly packed in a wooden case for safety
• With calibrated precision dial for direct reading in Degree Shore.
• Smooth precision-engineered components for exceptional performance.
• Supplied with calibration & inspection certificates.
• Weight: 415gms (0.913lbs)
• Dimension:
  

  Length	Depth	Height
  47.5 mm	55 mm	117.5 mm.
  1.9 Inch	2.1 Inch	4.6  Inch

Package Hardness Tester is used to determine the hardness for yarn bobbins, warp beams etc. To avoid a damage of bobbins and warp beams it is equipped with a ball-shaped indentation body. the covered distance of the indentation ball is proportional to the winding hardness and its transmitted by means of a movement (r=55 mm), for bobbins with a diameter of more then 400mm a flat working face is recommended. Depending on the material to be tested. Package Hardness tester with an indentation ball of 2.5 Ø mm , 5 Ø mm or 10 Ø mm are available.

• To determine the hardness of any cylindrical element in Degree Shore.
• Very useful for spinning mills to measure the hardness of rollers used in Ring Frame, Draw Frame, Roving Frame etc.
• Latest design with modern stylish look.
• Handy, easy to operate
• Duly packed in a wooden case for safety
• With calibrated precision dial for direct reading in Degree Shore.
• Smooth precision-engineered components for exceptional performance.
• Supplied with calibration & inspection certificates.
• Weight: 415gms (0.913lbs)
• Dimension:
  

  Length	Depth	Height
  47.5 mm	55 mm	117.5 mm.
  1.9 Inch	2.1 Inch	4.6  Inch

Package Hardness Tester is used to determine the hardness for yarn bobbins, warp beams etc. To avoid a damage of bobbins and warp beams it is equipped with a ball-shaped indentation body. the covered distance of the indentation ball is proportional to the winding hardness and its transmitted by means of a movement (r=55 mm), for bobbins with a diameter of more then 400mm a flat working face is recommended. Depending on the material to be tested. Package Hardness tester with an indentation ball of 2.5 Ø mm , 5 Ø mm or 10 Ø mm are available.