Dolphin Floor Adhesive

DOLPHIN FLOOR ADHESIVE is based on very special type of synthetic resin, with additives, tackyfier and fine grade mineral fillers. DOLPHIN FLOOR ADHESIVE is water based adhesive and compatible with most of substrates

- Multi-Purpose Floor & PVC Vinyl Adhesive. 
- Recommended for bonding of PVC sheet, Vinyl coverings and tiles, EPDM sheet, Polystyrene board, PU foam and similar material with concrete, metals and wooden substrates. 
- Suitable to most of porous and nonporous surfaces. 
- Recommended for both horizontal and inclined Structure. 
- Suitable also for use with under floor heating installations. However the heating should be switched off at least 48 hours before and after the installation of floor coverings.

Apply the adhesive uniformly on the substrate using a fine trowel, brush or roller. Allow the adhesive to set for approx. 15-20 minutes to become tacky then lay the floor covering. It is essential to ensure good contact between the floor covering and adhesive. Bonding over existing floor coverings should be avoided. Clean any excess adhesive with water immediately. Do not allow adhesive to dry.

Store away from sunlight and preferably below 30°C. Storage should be frost protected. DOLPHIN FLOOR ADHESIVE has 12 months shelf life if stored in required conditions