• Use Duplast CC-WB as supplied with 20 % dilution with water. Stir well before use.(rolling drums containing the product is an effective method).
• Apply after the final finishing operation as soon as the concrete surface has hardened sufficiently to prevent marring. Delaying the application until the next day will allow substantial loss of moisture reducing the effectiveness of the curing membrane. The surface should be damp but with no free water on it.
• In the case of formed concrete, apply immediately after striking the formwork.
• If the surface has dried out, dampen the concrete before application. For best results, apply an even coat by a low pressure spray equipment ( In all cases the nozzle of the spray of the spray should be held approximately 450 mm from the concrete surface and should be passed back and forth to ensure complete and even coverage. The pump pressure should be maintained at a level to produce a fine spray. Rate of application depends on requirements but is typically within the range of 160 ml to 200 ml / M² 96 psi to 5 M² per ltr.)or with a wide short nap roller or brush.
• With all methods, take adequate care to prevent marring of the concrete surface.
• Apply the curing compound evenly on all exposed concrete surfaces at a minimum rate of 5-6 M²/L so as to form a continuous film.

Actual coverage depends upon the method of application, the texture and porosity of the surface. The recommended coverage of Duplast CC-WB is 5-6 M²/L. Material requirement therefore is 0.2 L/M² after dilution of 20 % with water in single coat depending upon the substrate.

Duplast CC-WB is non toxic and does not normally require any special precaution while handling.

• Fire : Not flammable.
• It is advisable to wear goggles when spraying.
• Inhalation of the spray should similarly be avoided
• Should excessive skin contact with the compound occur the area of skin should be washed with soap and water
• If Duplast CC-WB comes into contact with the eye should be flushed with clean water for ten minutes
• If irritation persists, medical attention should be sought

• Use Duplast CC-WB as supplied with 20 % dilution with water. Stir well before use.(rolling drums containing the product is an effective method).
• Apply after the final finishing operation as soon as the concrete surface has hardened sufficiently to prevent marring. Delaying the application until the next day will allow substantial loss of moisture reducing the effectiveness of the curing membrane. The surface should be damp but with no free water on it.
• In the case of formed concrete, apply immediately after striking the formwork.
• If the surface has dried out, dampen the concrete before application. For best results, apply an even coat by a low pressure spray equipment ( In all cases the nozzle of the spray of the spray should be held approximately 450 mm from the concrete surface and should be passed back and forth to ensure complete and even coverage. The pump pressure should be maintained at a level to produce a fine spray. Rate of application depends on requirements but is typically within the range of 160 ml to 200 ml / M² 96 psi to 5 M² per ltr.)or with a wide short nap roller or brush.
• With all methods, take adequate care to prevent marring of the concrete surface.
• Apply the curing compound evenly on all exposed concrete surfaces at a minimum rate of 5-6 M²/L so as to form a continuous film.

Actual coverage depends upon the method of application, the texture and porosity of the surface. The recommended coverage of Duplast CC-WB is 5-6 M²/L. Material requirement therefore is 0.2 L/M² after dilution of 20 % with water in single coat depending upon the substrate.

Duplast CC-WB is non toxic and does not normally require any special precaution while handling.

• Fire : Not flammable.
• It is advisable to wear goggles when spraying.
• Inhalation of the spray should similarly be avoided
• Should excessive skin contact with the compound occur the area of skin should be washed with soap and water
• If Duplast CC-WB comes into contact with the eye should be flushed with clean water for ten minutes
• If irritation persists, medical attention should be sought