Eccentric Clamps

The eccentric clamp allows clamping with pull-down effect on different workpiece forms at low height.
Material
Case-hardened steel, case-hardened and blue zinc-coated
Assembly
Manufacture a thread with the corresponding distance L2 L3 to the workpiece.
Screw in the eccentric clamp at the necessary height and set it relative to the workpiece with its flat side.
Insert the workpiece and tighten the clamping pin using the internal hexagon. The proper tension is achieved after approx. 13 turn.
The threaded hole must be lubricated on a regular basis.
The rotational movement during tightening must always be completed towards the stops in order to prevent the workpiece from turning away from the stops.