Electro Permanent Magnets

Applications
for clamping of moulds in injection molding machines.
For clamping of mold in stamping machines.
Features
fmc, fast mould clamping system: these magnets help in changing the moulds very fast as the time required for clamping the mould is reduced to a few minutes.
Based on electro permanent magnet (epm) technology, which requires a pulse of electric current to switch on and then no electric power is required.
Fail proof holding system of moulds during power failure
machined from solid steel hence structurally very stable.
Patent applied, mould displacement monitoring circuit: this revolutionary circuit takes feed back from the magnet to check the displacement of the mould. This technology has been applied for patent. This system has many benefits over the conventional proximity switch type sensors.
Epoxy is 1.5mm below the surface hence no variation due to heat-up.
A wide range of pole configurations are available which gives us the flexibility to design the best suited and optimum solution as per customers requirments.