ELECTRONIC LED FREQUENCY METER

Storage Temp :-20°C to 70°C
Sampling Rate :2-3 samples/sec.
Insulation Resistance :greater than 20 mohms at 500v DC.
Power Consumption :less than 3VA (single scale), less than 6VA (double scale).
Supply TypeManufacturer, Exporter, Supplier, Retailer
Preferred Buyer Location All over the world

Product Details

Measuring Method :time measurement between consecutive cycles.
Operating Voltage :110V~125V, 220V-250V, 380V~440V.
Response Time :less than 1 sec.
Type :Electronic
Dielectric Strength :2KV RMS for 1 minute.
Sampling Rate :2-3 samples/sec.
Power Consumption :less than 3VA (single scale), less than 6VA (double scale).
Conforms To :I.S. 1248 / B.S. 89. / I.E.C. 51. (part - 4)
Insulation Resistance :greater than 20 mohms at 500v DC.
Humidity :upto 95% RH
Operating Temp :-10°C to 55°C
Display :box led, colour red/green, size 6.3 x 3.7mm
Storage Temp :-20°C to 70°C

It is used to measure the applied frequency, functionally similar to vibrating reed meter. The meter incorporates light emitting diodes LEDs which are used instead of vibrating reeds to indicate applied frequency. The frequency is determined by blinking LEDs. When applied frequency matches with the frequency marked on the dial, that particular LED blinks with maximum intensity. When the applied frequency is mid way between two adjacent LEDs, both LEDs blink. When the meter is switched on all the LEDs glow sequentially for a period of 1 to 1.5 seconds, thereafter it will indicate the applied frequency.

All voltage ranges are available in single meter. Terminal screws with washers are provided only for specific voltage as per requirement & remaining two terminals are covered with insulated caps. In case of 96mm & 144mm instruments, two sets of LEDs with the same scale range can be offered, giving two independent meters in one casing (Dual Scale). This facilitates in comparing the frequency of two voltage supplies for paralleling operation.

Features :