High Speed Sectional Warping Machine

Warping Table :

• Variable speed of warp table out of 500 steps gear ratios.
• Re-position of warp table and creel maintained by hand wheel.
• Flat reed with fine angular adjustment for section width.
• Two roll attachment for section tension control.
• Actual section width measuring scale device.

Warp Length Meter :

• Electronic "GERMAN" make counter meter.
• Machine automatic stop after predetermine warp length.
• To get desire actual warp length.
• Yarn length meter re-set by press and push button.

Beam Tension : Special designe develop by 'Bobbiler' to produce perfect weaver beam to get optimum efficiency for automatic looms. Boths pressure relief valve are separate for warping and beaming to get require beam tension control increase and decrease by manually of the yarn sheet during beaming.

Beaming :

• Integral robust beaming structure attached with machine structure.
• Wide range of warp lengths and beam flange dia.
• Both side movable beaming structure(Beam hold lever) on chrome plated pipe by hand wheel.
• Beam up-down facility by hydraulically.

Leasing Device :

• With this device Yarn layers do not accumulate any where, but they pass through the crossing comb & the guide thread comb, in open state, directly to the drum. So the tangle of threads among themselves is avoided. The crossover for the placing of crossing cords is very wide and permits the worker to introduce them comfortably & without any auxiliary means.
• The crossover formation is done by vertical movement of the crossing comb.