Hose Clip

Clamp shall be smooth and free from burrs and sharp edges. Clamp Produced other than from corrosion resistant material (Stainless Steel) shall be protected from electroplating coating of zinc as per Fe Zn12 of IS: 15731970 & BS: 1706-Zn3.Free running Torque Test : for this purpose the torque required to move the screw in either direction shall not exceed 1.5Nm i.e. (13.3 ibf In or 0.16 kgf I m) Torque Test : The Clamp shall be tightened to 75% of the Torque Load, as shown in table. On release, Clamp shall reveal no sign of permanent distortion of the housing, nor efficient functioning of the clamp size. The Clamp shall then be retightened until permanent distortion or failure occurs, at this point torque load shall be in excess of the value shown in table.