Hydraulic A/C Crimping Tool Kit

Apply Hydraulic AC Crimping Tool to sealing connection of the rubber hoses and their associated hose joints and accessories corresponding to the design module.

Do not increase the arm strength by expanding the handle, or the tools will be permanently damaged.

If the hose and joint are not in their places, the clip seat is not close to the cylinder bottom, or a module group does not match the hose joint, it’s impossible to start the piston handle. Furthermore the tools will be permanently damaged. In addition, keep no hand at any clipping point during use of the tools.

1. Avoid operation of hydraulic crimper at overload. Before use, retract the piston completely, and counterclockwise rotate the hand wheel if the pressure relief valve so that the crimping clip of hydraulic crimper can go back to the fixed clip seat.
2. Counterclockwise rotate the fixed clip seat of the hydraulic crimper so that it leaves the cylinder bottom, remove the movable pin connected to the key chain, and replace the crimping module group matching with the hose.
3. Select the copper or aluminium joint matching with the hose, insert the hose completely, and check the assembly in place.
4. Install the above hose joint in the clip seat, fold the movable clip seat to the fixed clip seat so that the pin holes of two clip seats can coincide, and completely insert the movable pin connected to the key chain.
5. Clockwise rotate the fixed clip seat of the hydraulic crimper so that it presses close to the cylinder bottom.