IP Camera Wire DC To Rj 45 Poe Cable

Passive PoEs range is normally formed 30-40 m/100-130 ft
It is suitable for using with products that basically do not support Power over ethernet
Each cable has a female RJ45 on one side which is adapted to a male RJ45 and 5.5×2.1 mm barrel jack connector on the other side.
Sometimes its hard to get power to your Ethernet devices. Wouldnt it be convenient to use the same cable for power and data Using these power over Ethernet Adaptors, you can do just that! The complete Passive Power over Ethernet Kit contains two pieces – INJECTOR and SPLITTER. It is suitable for using with products that basically do not support Power Over Ethernet. Each cable has a female RJ45 on one side which is adapted to a male RJ45 and 5.5×2.1mm barrel jack connector on the other side. The injector cable has a female barrel jack connector and thesplitter cable has a male barrel jack. CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adaptor Passive Power Over Ethernet SET is applicable for a wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices. The devices can be supplied standard power up to 50V. (The power Adaptor is not included – it is possible to use the power Adaptor of the powered device as an access point, IP camera, etc.) Passive PoE`s range is normally formed 30-40 metres/100-130 ft (the real distance depends on the power supply, type of cable and powered device). CAT-5-PASSIVE-POE-Power-Over-Ethernet-Injector-Splitter-Adaptor Simply attach the cables at each end of your network cable, plug the male barrel jack from the splitter into your target device and plug your desired power Adaptor into the injector. Now you can use one cable to provide both power and data for your Ethernet-enabled device. Complete set for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices such as D-Link, Ovislink, Senao, Wline, D-Link.