Linter Cleaner

Working principle of Linter Cleaner
Linter is discharged from a cyclone to the top chamber of the LC-410D Linter Cleaner. This chamber consists of two x 3 Meter' long, 500 MM diameter cylindrical beaters operating side by side in 550MM dia. Half round screen sections. Linter enters at one end of one beater, is conveyed to the opposite end and transferred to the opposite beater section. From this point, the Linter is once again conveyed over the screen section for the length the top section. Cleaned Linter discharged from the top section is pneumatically conveyed to the bale press.
Any Linter, which passes through the perforated screen of the top section, along with trash, is discharged into the first of the two pepper sections. These sections are clothed with fine wire mesh for the removal of the very fine hull particles (hull pepper) generated in the saw delinting process. Linter then passes to the reclaim section for final cleaning.The reclaimed Linter is then discharged and may be conveyed to a motes beater or recycled to the Linter cleaner. In addition to the 6 Meters of hull pepper removal screens the, LC410D also incorporates Automatic Screen Cleaning which blows down the entire length of both hull pepper sections with high-pressure air. Manual blow-down and unnecessary shutdown are eliminated. This also provides for consistent length of effective cleaning throughout the daily operations. This blow down system is PLC controlled and can be programmed for both duration & frequency of the air blasts.
Salient features of our Dryer Lint Cleaner
Maximum cellulose yieldCapacity – 15 TPD Linter28% greater cleaning surface area for first-pass cleaning than othersAdditional cleaning where needed most; three times the effective pepper section cleaning than the closest competitorReclaim section designed to accommodate any additional shale removal which may be required.Automatic screen cleaning; programmable to specific requirements