Magnetic Single V Block

MagTech Magnetic ‘V’ block’ is basically a clamping device. Hence, it is used in Standard Room Tool Room and Shop Floor also for Drilling, Grinding Light Milling operations.
The 'V’ Block has a total three magnetic surfaces. Top, bottom with 90 degree angle and end surface opposite from switch. Magnetic surfaces are activated by mechanical ON-OFF switch. All three magnetic surfaces and the two sides are carefully ground. The main ‘V’ angle and bottom surface are provided with hardened steel plates, that ensures extra wear resistance.
The accuracy of flatness and parallelism and squareness is within 5 microns for 4” & 6”; as well as 10 microns for 8” ‘V’ blocks. The following photograph can explain the product and its utilization briefly.
'V’ Blocks are required for Quality Control, Tool Room and Standard Room. Our Magnetic 'V’ Blocks have high magnetic pull, hence they can be used for drilling and grinding (both wet and dry) and even for light milling work.
When turned "ON" all three magnetic surfaces are activated simultaneously. The permanent magnet holds the work firmly in the 'V’ and if the block rests on a magnetically conductive surface, it is held firmly to this surface. The magnetic pull is constant and will not decrease even after long use. The magnetic system being shielded from penetration of moisture, cannot be damaged by coolants or other fluids.