MTS V BELTS

MTS V-BELTS ARE MANUFACTURED UNDER STRICT VIGILANCE AND OBSERVATION OF THE STATE OF ART OF MODERN TECHNOLOGY WITH REINFORCEMENT OF HIGHLY SHOCK - LOAD RESISTANT SYNTHETIC CORDS COMBINED WITH SPECIAL RUBBER COMPOUND AND ULTIMATELY JACKETED TO OBTAIN MAXIMUM LlFE AND SMOOTH RUN OF THE DRIVE.

. Cover... The bias-cut cover fabric is impregnated with special rubber to protect the inner part of the belts and provide strong abrasion resistance on the pulley groove.
B. Tension Member... The load carrying cords are tough polyester / aramide cords that have been specially treated to temper the cords to their point of high strength, low elongation and greater resistance to bending fatigue.
C. Top Compression Section... The rubber used in this section is compounded to withstand sudden shock loads and to keep the belt flexing readily when passing over the pulleys.
D. Insulation Section... The insulation section holds the tension binding section for extra strong adhesion between cords and the top and bottom compression section.
E. Bottom Compression Selection... This section holds the normal cross section of the belts and is compounded to resist compression fatigue and heat for longer service life.