Listing ID #1513180
Company Information
Ask for more detail from the seller
Contact Supplier
Buy corrosion resistant and highly durable Axis Hot Runner Temperature Controllers from us as per requirements. Our company is ranked among responsive and responsible traders and fabricators of a comprehensive assortment of Axis Hot Runner Temperature Controllers. They function optimally and guarantee long service life.
| Auto Control Mode | Computer-Calcu Cycle System |
|---|---|
| Control Accuracy | +-0.1 F(+-0.1 c) dependent on the total thermal system |
| Temperature Range | 32 to 999F (0 to 537c) |
| Temperature Stability | +-0.5% of full scale over the ambient range of 32 to 131F (0 to 55c) |
| Calibration Accuracy | Better than 0.2% of full scale |
| Power Response Time | Better than 0.3 second |
| Process Sampling | 100 milliseconds |
| F / c | Jumper-selectable |
| AdjComp Step Control Mode | Variable stepping voltage, phase fired |
| AdjComp Step System Duration | Approximately 5 minutes |
| AdjComp Step Output Voltage | Steps approximately from 25v RMS with 240Vac line output phase-fired |
| AdjComp Step Override Temp. | 221F (105c) |
| Compensated | Adjustable from 0-100% Maintain output Power to with 1% of setting |
| Operational Mode Priority |
|
| Safe Change Function | Use of the Safe Change feature does not eliminate the need for careful installation and removal of controller. |
| Voltages | 110 Vac or 240 Vac nominal, single phase |
|---|---|
| Power Capability | 15 amperes, 3600 watts 240 Vac, 15 amperes, 1800 watts 120 Vac |
| Overload Protection | Triac and load use high speed fuses, Both side are Fused(ABC-15 GBB, |
| Power Line Isolation | Optically and transformer isolated from ac line. Isolation voltage is greater than 2500 volt. |
| Output Drive | Internal solid state triac, triggered by ac zero crossing pulses |
| Setpoint Control | Two buttons up or down, Resolution1oF (1oc) |
|---|---|
| % Power Control | Two buttons up and down |
| Mode Control | Push button switch with LED indicator f or manual mode |
| Display | Top - 3-digit filtered LED, Bottom - 4-digit filtered LED |
| Status Indicators | Heater output,Soft-Start,Manul,alarm |
| Power On-Off | Rocker Switch,UL,CSA approved |
| Input Voltage | 110 ~, +/240Vac, -10% |
|---|---|
| Voltage Frequency | 50-60 HZ |
| DC Power Supplies | Internally generated, regulated and temperature compensated |
| Module Power Usage | Less than 6 watts,exciuding |
| Dimensions | Load 2" W * 7" H * 71/2" D(5.08cm*17.78cm*19.05cm) |
| Thermocouple (T/C) sensor | Type "J" grounded or ungrounded, Type "k" (Jumper-selectable) |
|---|---|
| External T/C Resistance | Maximum 100 ohms for rated accuracy isolated from ground and supply voltages |
| T/C Isolation | Automatic, better than 0.02 F/ F (0.01 c / c) Potentiometric |
| Cold Junction Compensation | Diode clamp, RC filter 10 Megohms |
| I nput Type | |
| I nput Protection | Better than 0.05 F/ F(0.03 c / c) |
| I nput Impedance | Greater than 999 F (0 to 537 c) |
| I nput Amplifier Stability | Greater than 100dB |
| I nput Dynamic Range | Greater than 70dB |
Connect with us
For Buyer 
For Seller 
Help 
