PP Vertical Pump

STRYKER series vertical PP pumps can be used in any installation or specially where the saving of space is important factor or mechanical seal not required. These pumps are designed for use where the liquid handled to be of highly corrosive nature or where non-adherence of product or zero metallic contamination is must.

These pumps are equally ideal for continuous or intermittent service for handling corrosive as well as ultra pure chemicals without fear of corrosion or contamination. All components in the wetted end of the pump are molded of engineered plastic. These pumps are not only less costly than high alloy or exotic metal pumps, but they may be used safely in service where metal pumps are completely inadequate.

Special Features

• Bearing free design for handling abrassives in solutions.
• Motors are flange mounted Single or Three Phase TEFC from 1 HP to 10 HP.
• Epoxy / Polyurathene paints are used on metallic Bearing Housing.
• No metal in contact with solution. No danger of Corrosion or contamination.
• Heavy plastic sleeves isolates steel shaft from liquid being pumped.
• Radial vanes on backside of impeller increase flow of fluids through the sleeve bearing preventing overflow at top of column.
• Lubrication of bearings by product itself or by fresh water.
• All models operate at 1450 rpm / 2900 rpm.
• Specially designed vapour seal provided to protect bearing form corrosive fumes.
• Dynamically balanced impeller made from glass-filled reinforced engineered plastic.
• Bearings of High Allumina Ceramic Sleeves. Purity 99.5%.

These pumps are in extensive use in the fields of

• Pollution Control open tank.
• Filtration
• Transferring Corrosive Chemicals
• Slurries
• Plating Bars
• Sewage
• Waste Water Treatment Plant.