Reva Filter Press

Reva make filter press comprises a set of vertical,juxtaposed recessed plates, presses against each
other by hydraulic jacks at one end of the set. The pressure applied to the joint face of each
filtering plate must withstand the chamber internal pressure developed by the sludge pumping system. This vertical plate layout forms water tight filtration chambers allowing easy mechanisation for the discharge of cakes. Filter clothes finely or tightly meshed are applied to
the two grooved surfaces in these plates.screw pump feed the sludge to be filtered
under pressure in the filtration chamber. They are usually placed in the center of the plates allowing a proper distribution of flow, right pressure and better drainage of sludge within the chamber. Solids sludge gradually accumulates in the filtration chamber until the final compacted cake is formed. The filtrate is collected at the back of the filtration support and carried away by internal ducts.
The filter press are available in required different plate sizes. Manual hydraulic and fully automatic hydraulic power pack.
1. 470mm x 470mm.
2. 610mm x 610mm.
3. 800mm x 800mm.
4. 915mm x 915mm.
5. 1200mm x 1200mm