Self Leveling Epoxy

We are offering self leveling epoxy is based on high performance epoxy resin & curing agents. It is sold under the brand name gal – sl and has a three-component system, consisting of resin, curing agent and carefully graded iron free fillers. Product is self-leveling to achieve excellent gloss, attractive, hygienic and very hardwearing & chemical resistant finish. features

• being smooth, joint less and monolithic surface it is very easy to clean and to make it dust free
• product is based on high performance epoxy resin & curing agent system. The flooring system has excellent overall chemical resistance at ambient temperature
• a carefully selected and graded high wearing aggregate gives very strong floor toppings to withstand normal foot and light vehicular traffic
• system is available in many attractive colors

uses self leveling epoxy is highly recommended, for use, for extremely hygienic condition, chemical resistant and dust free areas like:

• automobile industries
• pharmaceuticals & aesthetic areas
• food processing areas
• bottling plants
• electronics industries
• hospital operation theatres
• chemical plants

surface preparation for successful performance of self leveling epoxy or any other flooring system can achieve only after proper surface preparation. It is the prime requirement that surface must correctly prepared before application.

• new concrete surface must be cured for 28 days
• surface must be free from any oils, grease, loose partials, curing aid chemicals, previously applied coating etc
• surface must be fully dry
• for old surface, all cracks, cavities should be repaired with gal epoxy putty
• this is a very thin topping so cannot level any irregularities of levels of the original sub-base. Therefore, it is most important to make original surface in line & level, before application of self leveling epoxy

application (primer coat) apply one coat of self leveling epoxy primer on properly prepared surface by brush and allow it to dry. self level toppling first mix the resin part a, thoroughly with slow speed mixer until uniform color is achieved. then add curing agent part b and mix again with mixer (@less then 80 rpm). After that add filler par c and mix with mixer until a homogeneous, lumps free mass is achieved (@less then 80 rpm). Then, pour it on primed surface and work with notched trowel to required thickness and apply spike roller to remove air. Proper mixing is the key factor to get uniform color and smooth surface. storage all the components resin, hardener & filler must be kept in cool, dry place and in covered shed. health & safety it is advisable to wear protective wears at the time of use of self leveling epoxy and all other gal brand products. In case of contact with eyes and skin, wash with plenty of water and consult a doctor.