Server Memory

We are offering server memory this document describes valueram's 2g x 72-bit (16gb)
ddr3-1600 cl11 sdram (synchronous dram), registered w/
parity, 2rx4 ecc, intelâ® compatibility tested, memory module,
based on thirty-six 1g x 4-bit fbga components. The spd is
programmed to jedec standard latency ddr3-1600 timing of
11-11-11 at 1.5v. This 240-pin dimm uses gold contact fingers.
The electrical and mechanical specifications are as follows:
features
� jedec standard 1.5v (1.425v ~1.575v) power supply
� vddq = 1.5v (1.425v ~ 1.575v)
� 800mhz fck for 1600mb/sec/pin
� 8 independent internal bank
� programmable cas latency: 11, 10, 9, 8, 7, 6
� programmable additive latency: 0, cl - 2, or cl - 1 clock
� 8-bit pre-fetch
� burst length: 8 (interleave without any limit, sequential with
starting address �000� only), 4 with tccd = 4 which does not
allow seamless read or write [either on the fly using a12 or
mrs]
� bi-directional differential data strobe
� internal(self) calibration : internal self calibration through zq
pin (rzq : 240 ohm â± 1%)
� on die termination using odt pin
� on-dimm thermal sensor (grade b)
â�¢ average refresh period 7.8us at lower than tcase 85â°c,
3.9us at 85â°c
� asynchronous reset
� pcb : height 1.180� (30.00mm), double sided component.