Shunan Cementitious Glue

We are offering shunan cementitious glue for expanded polystyrene sheets.
shunan thermal eps adhesive mortar, cementitious glue for expanded polystyrene sheets sa801
for adhesion of extruded or expanded polystyrene/foam plastic forms to various surfaces for the purpose of interior and exterior insulation of constructions.
single component based on cement adhesive, when mixed with water, it forms an adhesive specially indicated for spot bonding of insulating materials such as expanded polystyrene sheets and rock wool to construction supports.
usage
for fixing expanded polystyrene boards for thermal insulation of buildings, ideal for joining polystyrene foam to construction supports, on concrete walls, brick partition walls, renders, filled walls with mortars and all the surfaces that require insulation
product information
packaging information
weight: 25kg
color: grey
consumption: 4.5~5.5kg/m2
shelf life and storage: 6 months after manufacturing date in dry ventilated place
standard: jg149-2003
product advantages
â·good adhesive strength with substrate and eps board
â·good application property
â·good anti-slip property
â·single component and only mix with water, easy to be controlled
â·good compatibility with other components of the whole system
field of application
the function of this product is to fix the thermal insulation layer onto the wall
how to use:
1. Leave the bucket with the adhesive for several minutes, before mixing it
2. Mix the compounds thoroughly, on one hand manually, by using a trowel or mechanically, by using a drill mixer.
3. Use a trowel to apply mortar alongside the edges of the boards, as shown in the image. The thickness of the adhesive shouldn�t be greater than 1�/2.5 cm, as otherwise you won�t be able to fix them properly on the concrete wall. If the wall surface has numerous irregularities, it is better to apply the mortar over the polystyrene boards, as shown in the image. basically, all you have to do is to apply six mounds of adhesive on the polystyrene sheet.
4.after we have applied the adhesive on the polystyrene sheet,we have to install them horizontally on the concrete wall. Consequently, you should start fixing the boards from the bottom corner of the wall, using a full sheet.
5. Continue installing the polystyrene sheets until you reach the end of the row. Make sure the edges of the boards are aligned each other, as to make a professional job.
6. the next row should be installed vertically, as to give better strength to the insulation. Work carefully, as to make sure the boards are level and aligned properly. If you need a smaller piece than a full board, you have to use a hand saw to make the cut.
product specification
substrate requirement
the substrate should be sound, dry, flat, clean and durable
preparation
1) clean the substrate with high pressure water
2) remove the old paint and putty on the substrate
frost should be avoided
3) repair the crack or joint in the substrate. Next step at least 48h later
4) the surface must be leveled and the deviation must be less 4mm
safety
1) may cause serious damage to eyes
2) may be sensitive to skin in case of contact. Lrritable for eyes,respiratory system and skin
3) keep out of the reach of children
4)avoid breathing the dust
5) in case of contact with eyes,rinse eyes immediately with plenty of water and consult a doctor
shunan eps system is a lightweight, low density system employing expanded polystyrene insulation with adhesive and mechanical dowel fixings
sa801 is a part of shunan - external wall insulation systems external building walls, the finishing coat can be tile or plaster
shunan's eps system build up
1. Substrate(e.g.,concrete)
2. Adhesive/attachment(sa801)
3. Insulation foam
4. Bast coat and protective mortar
5. Mesh reinforcement
6. Anchor
7. Protective mortar
8. Flexible tile adhesive
9. Wall bricks
10. Flexible tile grout