Single Cable Flame Spread Tester EN50086

Introduction:
single wire and cable vertical burning tester is themost widely used and low cost of cable fire performance test equipment; single wire or cable burning tester meet the national standard gb t18380.11-2008 iec60332-1-1: 2004 requiremen. It is to test cable , flameretardant insulation layer under fire conditions applicable for testing wireand cable in overheating, overcurrent and other non-normal state. It can beused in vertical or fiber optic wire and cable flame spread test, while testunder fire conditions dettol matter combustion conditions.
International standards:
iec 60332-1-1,2,3
en 50086-1-1994
gbt 18380.11,12-2008
features:
1, the touch screen intelligent control system; english user interface;
2, the system automatic ignition, automatic timing, automatic datastorage;
3, the test section and the control section is conbined design in onebox for operation;
4, stainless steel test box, the internal cavity size: height 1200mm,width 300mm, depth of 450mm;
6, a pre-mixed burner, an inner diameter of ¢ 12 ± 0.5mm, length is 100mm. 1kw hybrid standard burner,which provides accurate test fire source;
7, the flame burning applied time and hold time can range from 0 to 99 minutes99 seconds range adjustment. Automatic control of the testing process.
8, import needle vavle precisely adjust the flame height, according tostandards, thef blue flame height is 50mm ~ 60mm, total height 170mm ~ 190mm
9, the gas flow rate is controlled by needle valve
10, equipped with a steeless flame height caliper.
Specifiction:
size
600(w)×450(d)×1250(h)mm
gas pressure
0.1mpa
power ac220 v +- 10v 50hz;
weight 60kg
model gd18380a
gas purity propane> 95%; compressed air