Single point diamond dresser

The maximum depth of cut achieved per dressing pass is 0.03 mm or on fine grit wheels,
approximately 0.005-0.01 mm. ( Single Point Diamond Dressers )
The cross feed rate is dependent upon grit size and can have a marked influence on the quality of the finish imparted to the grinding wheel surface. The lower the feed rate, the finer the surface finish.
We would recommend the following feed rates per revolution of the grinding wheel.
An ample supply of coolant should be directed at the diamond point before dressing begins, as the sudden application of coolant to the diamond once it has heated up can cause it to shatter.
The diamond holder should not be set directly on the center of the grinding wheel, but at an angle of
5-15 to the direction of rotation of the wheel so that it appears to be "trailing"