• Permanently captivates into sheets as thin as.040" 11.02 mm and greater.
• Replaces loose hardware
• Available with jacking feature or axial float feature.
• Appropriate for close centerline-to-edge applications
• RoHS compliant

Type SCB'"' Spinning Clinch Bolt is a one piece fastener that installs by simply pressing it into a properly sized hole. The controlled clinching action permanently captivates the screw in the panel yet still leaves it to spin freely in the sheet. This allows quick attachment of mating hardware, eliminating much of the need for loose fasteners, such as screws and retaining clips or washers. or expensive multi-component fastener assemblies.

The Spinning Clinch Bolt can also be used with the PEM Type N10 receptacle nut (see PEM Bulletin PF) and with the PEM Type RAS R'ANGLEg fastener .

• Punch or drill properly sized mounting hole in sheet
• Place the fastener through mounting hole and into anvil. A flat or recessed punch can be used
• With punch and anvil surfaces parallel, apply squeezing force to the top of the screw head and the underside of the sheet material. The squeezing action forces the shoulder of the screw into the sheet, displacing sheet material, causing it to fill the void under the head and shoulder of the screw

• Permanently captivates into sheets as thin as.040" 11.02 mm and greater.
• Replaces loose hardware
• Available with jacking feature or axial float feature.
• Appropriate for close centerline-to-edge applications
• RoHS compliant

Type SCB'"' Spinning Clinch Bolt is a one piece fastener that installs by simply pressing it into a properly sized hole. The controlled clinching action permanently captivates the screw in the panel yet still leaves it to spin freely in the sheet. This allows quick attachment of mating hardware, eliminating much of the need for loose fasteners, such as screws and retaining clips or washers. or expensive multi-component fastener assemblies.

The Spinning Clinch Bolt can also be used with the PEM Type N10 receptacle nut (see PEM Bulletin PF) and with the PEM Type RAS R'ANGLEg fastener .

• Punch or drill properly sized mounting hole in sheet
• Place the fastener through mounting hole and into anvil. A flat or recessed punch can be used
• With punch and anvil surfaces parallel, apply squeezing force to the top of the screw head and the underside of the sheet material. The squeezing action forces the shoulder of the screw into the sheet, displacing sheet material, causing it to fill the void under the head and shoulder of the screw