Stainless Steel Wire Mesh, Wire Gauge : 1-5mm

Stainless steel wire mesh faq
what is your standard of wire checking?
we check the wire according to the national standard (gb5330-85) and our enterprise regulation about raw material defects and relative solution.
What is your standard of checking finished products?
we check quality of end products according to china national standard gbt17492-1998, equivalent iso9044:1990, and our own standard.
What is the major checking items of stainless steel wire mesh?
first, we check the basic data: wire diameter, mesh counts, roll width and roll length.
Secondly, the surface condition: opening, color, flat or not and defects.
Thirdly, the edge of wire mesh should be neat and without defects.
What is your checking standard of reed?
the steel reed should be flat and clean, with correct wire going, the inside height, inside length and thickness should be correct.
What is the stainless steel material your company usually uses?
we mainly use ss304（0cr18ni9） ss304l(00cr9ni10) sa316(0cr17ni12mo2)
ss316l(00cr17ni14mo2), also ss410, ss4101 and ss430 sometimes.
What is the general packing requirement?
stainless steel woven wire mesh is rolled around paper tube first, moisture-proof paper outside or plastic fabrics. Customized packing available.
What are the common wire mesh defects?
1. Folding marks: the stripe marks on wire mesh surface that cannot be erased.
2. Broken holes:
multi-pieces broken wires at same site to form a hole in the surface.