Operated by tractor PTO has cutter bar reel, feeding auger and bruising cylinder like a traditional thresher. Straw thrown and stubble left by the grain combine is collected by straw combine and delivered to the cylinder concave section, where it is cut into pieces and passed through the concave. A reciprocating cutter bar is used for reaping the standing stubbles and the portion of the straw left uncut by the combine harvester. Straw, which passes through the concave, is aspirated by a blower and fed into a trolley on rear side covered by a wire net. For recovering the left grains from the straw, a sieve system is provided below the concave.
The tyres fixed on the reel pipes push the straw of wheat crop left after combine operation towards the oscillating cutter bar after which the harvest straw reaches the threshing drum after passing Auger and guide drum. The wheat Straw gets crushed in very small pieces in the threshing unit. The product fine straw is sucked by the blowers and is then pushed towards the outlet pipe by blower and which is collected in the Trailer fitted with wire mesh.
Straw Reaper is used to make straw from stubbles of wheat after combine harvest. All its components are systematically matched to make efficient use of tractor power & save fuel. The Dasmesh straw reaper shows their quality by their performance, efficiency & durability.

Operated by tractor PTO has cutter bar reel, feeding auger and bruising cylinder like a traditional thresher. Straw thrown and stubble left by the grain combine is collected by straw combine and delivered to the cylinder concave section, where it is cut into pieces and passed through the concave. A reciprocating cutter bar is used for reaping the standing stubbles and the portion of the straw left uncut by the combine harvester. Straw, which passes through the concave, is aspirated by a blower and fed into a trolley on rear side covered by a wire net. For recovering the left grains from the straw, a sieve system is provided below the concave.
The tyres fixed on the reel pipes push the straw of wheat crop left after combine operation towards the oscillating cutter bar after which the harvest straw reaches the threshing drum after passing Auger and guide drum. The wheat Straw gets crushed in very small pieces in the threshing unit. The product fine straw is sucked by the blowers and is then pushed towards the outlet pipe by blower and which is collected in the Trailer fitted with wire mesh.
Straw Reaper is used to make straw from stubbles of wheat after combine harvest. All its components are systematically matched to make efficient use of tractor power & save fuel. The Dasmesh straw reaper shows their quality by their performance, efficiency & durability.