Suction Inlet

The Inlet is fitted to the wet end casing and to receive wear on its body instead of impeller. Chambers are made of material compatible with the impellers. There are close running clearance between these components and can be easily replaced to maintain efficiency. The clearances between impeller and inlet have been maintained at 0.75mm. In case of wear, this clearance increases the same can be maintained by adding spacer. And suction inlet can also be reused after re-machining its inner surface.

Advantages:

• FLOWEZYY spares are durable and has a long wear resistance life
• Quick payback on investment
• Superior quality casting gives dimensional and hydraulic repeatability to exceed performance
• Highly demanded for abrasive and corrosive application
• Continuous Research and up gradation on tailor made spares
• High rugged reliability with excellent service support
• The highest yield at a lowest input allowing the balance between the quality and price, followed by low maintenance cost result in substantial saving
• Indigenously manufactured spare components result in faster delivery and easy spare availability
• Better interchangeable- substitute of spares as compare to OEM
• Massive reduction in spares consumption
• Manufactured under strict supervision