TS Gas Liquid Separators

"Wright Austin TS Gas Liquid Separators for up to 60% by weight of the units flow capacity"

Wright Austin TS style air liquid separators are designed to remove 99% of all liquid droplets and solid particles greater than or equal to 10 microns in size. The TS style can handle a higher volume of entrained droplets/particles than the standard T style. Wright-Austin TS style gas/liquid separators are typically used for applications where higher than normal liquid loading causes a "slugging" problem, common to refinery and chemical plant applications. TS gas/liquid separators are used upstream of gas turbines, adsorption towers, gas scrubbers and steam generator outlets.
Moisture laden gas enters the TS style separator and is deflected downwards in a centrifugal motion. The reduction in velocity separates out the liquid, which falls below and coalesces under the patented Vortex Containment Plate (VCP). The VCP prevents reentrainment of the liquid into the gas. The resulting dry, clean gas flows upwards and exits through the outlet of the separator. Wright Austin accomplished this without complex baffles, deflectors and other structures that obstruct the flow-stream and this results in very low pressure drops.
TS style gas/liquid separators are fabricated from carbon steel, 304SS, 316SS and can also be fabricated from exotic alloys when needed.
TS style gas/liquid separators are available with ASME code stamp and CRN. All fabricated TS style gas/liquid separators are designed in New Jersey (USA) in accordance with ASME Section VIII, Division I.