My ExportersIndia

For Buyer

For Seller

For Help

Thyristor

We offer a complete product range of Fast Switching Thyristors

Fast Switching Thyristors

  • Frequency 400 MHz to 440 MHz
  • Availability 5 gms
  • Operating Temperature -40° to +85° C
  • Parameters Value
  • Part Number RDM-A4FZ
  • Interface Single board transceiver with SPI Interface
  • Receiver Sensitivity −119 dBm at 1 kbps, FSK.
  •   −114 dBm at 9.6 kbps, FSK
  • Supply Voltage 2.3 V to 3.6 V
  • Power Consumption In Receive mode: 18 mA
  •   In Transmit mode: 22 mA (at 10 dBm output)
  • RF Output Power Programmable output power from -20 dBm to +13 dBm in 63 steps
  • Data Rate 1.2 kbps to 19.2 kbps
  • Modulation FSK, GFSK, ASK, OOK and GOOK
  • Antenna Options SMA Whip Antenna
  • Dimension 40.34 x 31.72 (L x W) in mm
  • Compliance FCC: Yes IC: Yes Europe/ETSI: Yes RoHS: Yes
  • Other Features On-chip VCO and fractional-N PLL
  •   On-chip 7-bit ADC and temperature sensor
  •   Fully automatic frequency control loop (AFC) compensates for lower
  • Data Sheet Download
  • Application Note Download
  • Sample Code Download

The VCO operates at twice the fundamental frequency to reduce spurious emissions and frequency pulling problems. The transmitter output power is programmable in 63 steps from 20 dBm to +13 dBm. The UHF transceiver module RF frequency, channel spacing, and modulation are programmable using a simple 3-wire interface. The RF transceiver module operates with a power supply range of 2.3 V to 3.6V and can be powered down when not in use. A low IF architecture is used in the receiver (200 kHz), minimizing power consumption and the external component count and avoiding interference problems at low frequencies.
The RDM-A4FZ supports a wide variety of programmable features, including Rx linearity, sensitivity, and IF bandwidth, allowing the user to trade off receiver sensitivity and selectivity for current consumption, depending on the application. The receiver also features automatic frequency control (AFC) loop, allowing the PLL to compensate for frequency error in the incoming signal. An on-chip ADC provides read back of an integrated temperature sensor, an external analog input, the battery voltage, or the RSSI signal, which provides savings on an ADC in some applications. The temperature sensor is accurate to 10C over the full operating temperature range of 40C to +85C. This accuracy can be improved by doing a 1-point calibration at room temperature and storing the result in memory.Applications



  • Low Cost Wireless Data Transfer
  • Wireless Medical Applications
  • Remote Control / Security Systems
  • Wireless Sensor Networks
  • Keyless Entry
  • Home Automation
  • Process And Building Control
  • Automotive Systems
  • Active RFID Solutions
  • AMR Automated Meter Reading
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us