7-13% increased good metal yield due to reduction of surface defects and the number of blank heating times. : -1.7-2.0 times decreased allowances thus allowing to save from 30 up to 70 kg of metal per 1 t of forged parts. Min. 1.5 times reduced power consumption per 1 t of forged parts
increase in metal recovery by 15-50 % via decreasing tolerances : energy savings by 2-4 times
Designed for four-side radial forging performed by hydraulic forging presses up to 120 MN. : -1.5-2.5 times increased efficiency of the forging process.
We are offering Four Die Forging Hammer has No Analogues in the World! device Can Be Installed On Your Hydraulic...
We are offering diesel pile hammer. Diesel hammers for driving of concrete and steel piles: tubular (ram mass 1, 2 tons � 5 tons) diesel pile driving hammers are designed for the reinforced concrete and steel piles and sheet piles driving...
We are offering forging hammer. Weight of falling part 16t completed with new anvil weight of a dropping part, kg 16.000 impact energy, kgm 40.000 max. Distance between a table and the slide block, mm 1500 the enclosed altitude, mm 1180 slide block...
For Buyer 
For Seller 
Help 
