SE-Test Lab Instruments (I) Pvt. Ltd. - Testing Equipments

It consists of a sheet metal box mounted on Legs and fitted with a series of chutes of equal width which discharge the material alternatively in Opposite Directions into separate pans. The chutes of the Riffle are steep enough to allow rapid flowing of the Materials.
The unit offered are supplied in a range of sizes from 7 mm to 75 mm

24 Hour cycle from time of mixing.Controlled 35 C or 100 C 2 C Curing Temperature for concrete.Controlled 27 C 2 C Curing Temperature for grey cement.

The tank has been designed to accommodate 150mm / 70.6mm cube moulds upto 36/72 cube mould and fully insulated, complete with a hinged lid, heater, thermostat and re-circulated pump. Provision of two removable racks allowing free circulation of water around each mould. The pump, drain valves and electrical equipment are housed in a compartment located at one end of the tank. The Tank is heated by an immersion heater under normal conditions and refrigeration system for grey cement the temperature is controlled at 35 C or 100 C 2 C / 27 C +2 C, expect for the 15 minutes after immersion of the freshly made specimens

One of the primary functions of a drilling fluid is to carry drilled solids from the well bore. These solids are a contaminant, and if left in the system, can lead to numerous problems. The offsite sand content kit determines the volume percent of sand-sized particles in the drilling fluid. Api defines sand-sized particles as any material larger than 74 m (200-mesh) in size. The test can be performed on low solids fluids as well as on weighted fluids. The kit consists of a glass tube graduated to read percent (%) by volume, a funnel, and a 200-mesh sieve contained in a cylindrical shaped holder. Consists of sand content kit, complete, with sieve, funnel, graduated tube, wash bottle & carrying case

The instrument consists of a channeled or a round base over which two vertical pillars are fixed. An adjustable cross plate is at the top. A dial gauge, reading to .002mm x 5mm. Can be located upon a 6.5mm. dia ball or other reference point cemented in the specimen. On the base there is similar recessed seating in which can be placed a second ball or reference point in the specimen. Complete with a stainless steel standardization bar with insulated grip and with 6.5mm dia. Balls mounted in the ends. The unit can be supplied with an Electronic Dial Gauge at extra cost if indicated at the time of placing the order.