The STYRAX Clean Room Process Monitor has been specially developed keeping process measurement requirements of CLEAN ROOMS in Pharmaceutical industries. The Process Monitor can measure Temperature, RH Inbuilt integral Sensor, Differential Pressure Inbuilt sensor or three analog inputs or two analog inputs and inbuilt differential pressure sensor. It has on demand dew point display. The Monitor has status LEDs for process violation indication. RH, Temperature and Differential pressure will display individually and data transfers to any master device on MODBUS RTU RS-485 communication. It also has communication diagnosis LED. The monitor has inbuilt buzzer for audible process violation. It has keypad to program and calibrate the instrument by user. It has Stainless steel Modular Face plate, which is designed as a mounting accessory for monitor suited for Brick and Modular wall for Clean Room applications where you need flush mounting mechanism.

• Advanced Microcontroller based process measurement.


• Programmable channel ranges and unit selections.


• Programmable resolution.


• 4 Digit, 0.39 bright 7- Segment LED display for displaying Temperature, RH and DP.


• User selectable set limits for process value violation.


• Process parameter status indication with 3 Bi-Color 3mm LEDs.


• Inbuilt buzzer to audible process value violation.


• Password protection for calibration and programming mode.


• Software Calibration for 3 channels.


• MODBUS RTU multi drop RS-485 serial communication for PLC, SCADA, etc.


• Programmable baud rate between 9.6k/19.2k/38.4k.


• Diagnosis indication of Communication with master.


• User programmable offset correction.


• Brick and modular wall mounting.


• Stainless steel enclosure.

Inbuilt Integral Sensors/4-20mA/0 to 10VDC.

the styrax multi channel indicator has been specially developed keeping process measurement requirements of pharmaceutical industries. The multi channel indicator can measure temperature sensor (pt100) or 4-20ma or 0-10vdc. Configurable set points for pfc outputs. Display measured values data transfers to any master device on modbus rs-485 communication. It has keypad to program and calibrate the instrument by user. It has ms powder wall mounting enclosure.

• advanced microcontroller based process measurement.


• software programmable channel ranges and unit.


• programmable resolution.


• 4 digit, 2.0 bright 7- segment led display.


• unit's display using high brightness led's.


• user selectable set limits for process value violation.


• inbuilt buzzer to audible process value violation.


• configurable set limit for potential free contact.


• configurable hysteresis for pfc set point.


• pfc outputs for all channels.


• password protection for calibration and programming mode.


• software calibration for all channels.


• modbus rtu multi drop rs-485 serial communication for plc, scada, etc.


• programmable baud rate between 9.6k/19.2k/38.4k.


• user programmable offset correction.


• wall mounting.


• ms powder coated enclosure.