Transmitter Accept input RTD, Thermocouple Transmitter output available 4-20 mA ( 2/3/4 wires) Out put Range -999 to 9999 counts DIN Rail / Head mounting , Power supply : 12-36 VDC (or )230 VAC Output Load at 20 mA , 600 ohms maximum @ 24 VDC With Display optional , Range select at factory Single/ Dual Input optional

Transmitter Accept input RTDs, Voltage , current Process Temperature and Humidity Temperature Range : 0 to 50 Deg C
Temperature Out put : 0 /4-20mA ( 2 Wire)
Humidity Range : 0 to 100 % RH
Humidity Out put : 0 /4-20mA ( 2 Wire)
Calibration Zero and Span adjustment
Accuracy :2%rh/0.3k, Power supply : 12-36 VDC
Output Load at 20 mA , 600 ohms maximum @ 24 VDC With Display optional , Range select at factory Single/ Dual Input optional , wall mounting

The HygroFlex1 series is the latest development in inexpensive HVAC transmitters for relative humidity and temperature. The devices are equipped with the tried-and-tested Hygromer IN-1 sensor and boast unbeatable value for money. The optional ROTRONIC HW4 software enables you to change the scale and calibrate and adjust the transmitter

Measuring range : from 0/+100 Pa to -1000/+2000 mBar Configurable intermediary and center zero range Range Scalable , unit selectable , ABS IP 65 Housing Unit : Pa, mm HO, mbar, inWG, mmHg, Kpa, PSI Dip switch selection , With or with out display , 0-10 V or 4-20 mA output, active sensor, power supply 24 Vac/Vdc (3-4 wires) or 4-20 mA output, passive loop, power supply 18 to 30 Vdc (2 wires)

Measures Humidity, Temperature and Calculates Dew / Frost Point Temperature Compensated humidity signal Standard Scaling : 420mA = 0.100%rh / -50.200 C Temperature Ready for direct 3 - wire RTD connection housing and can also be supplied in an industry standard IP65 case Probe with Adjustment Profile Standard Factory Adjustment Certificate Adjusted at 23C and 10, 35, 80%rh over a wide -50 200C range with integrated cable Accuracy 1%rh/0.2k, power supply of 10-35 VDC or 12-24 VAC

Measuring range : from 0 -5 m/s to 30 m/s from -20 to +80 C Easy mounting with the 1/4 turn system with wall-mount plate unit selectable m/s and fpm , ABS IP 65 Housing Selectable Range : 0-5/0-10/0-15/0-20/0-30 m/s Dip switch selection , With or with out display , 0-10 V or 4-20 mA output, active sensor, power supply 24 Vac/Vdc (3-4 wires) or 4-20 mA output, passive loop, power supply 18 to 30 Vdc (2 wires)

High Accuracy and High Temperature -40 120 C Measuring results at high flow velocities of up to 40m/s( 8000ft/min) the transmitter calculates the volumetric flow rate in m/h or ft/min energy efficiency, long-term stability and reproducibility Low angular Dependence, Easy Installation volumetric flow rate can be displayed and directed to one of the outputs Ranges available 0.062m/s, 10, 40 m/s ( 8000 ft/min) Output available 0-10 VDC / 4-20mA and free scalable range Operating Temperature -40 120 C ( -40 248 F)

CO2 , relative humidity (RH) and temperature (T) measurement in one housing new standards in CO2 measurements for HVAC version for CO2 and T can be easily extended with a RH plug-in module energy efficiency, long-term stability and reproducibility The operation is based on the infrared principle mounting concept stands for easy installation and replacement within seconds Ranges available 02000/5000 ppm, 1090%rH, -555 C Output available 0 5/10 VDC / 4-20mA Operating Temperature 0 50 C , AC/DC operated

U5100 series pressure transducers from the Microfused line of MEAS over voltage protected to 16Vdc in both positive and reverse polarity solid piece of 17-4PH stainless steel (316L optional) withstands more than 10 million pressure cycles without failure Heavy Industrial - High EMI Rated , Extended temperature range -40 to 125 C Operating Temperature , Accuracy: 0.25% FS BFSL Ranges : 0 Bar to 1000 Bar , Universal Supply 9-30VDC Output :1-5VDC, 0-10 VDC (3Wire), 4-20mA ( 2 wire) Process connection : inch BSPM, only Gage

US10000 pressure transducers from the UltraStable line of MEAS over voltage protected to 16Vdc in both positive and reverse polarity IP65, NEMA 4, 100% Stainless Steel Isolation withstands more than 10 million pressure cycles without failure Advanced Digital Compensation of both Temperature and Non Linearity -25 to 85 C Operating Temperature, Accuracy: 0.05% FS BFSL Ranges : -1 Bar to 700 Bar , Universal Supply 9-30VDC Output :0-5VDC, 0-10 VDC (3Wire), 4-20mA ( 2 wire) Process connection : inch BSPM, gage and absolute

High Strength Stainless Steel Construction Wide Operating Temperature Range Low Static and Thermal Errors , EMI/RFI Protection Compatible with Wide Range of Liquids and gases -40 to 85 C Operating Temperature , Accuracy:

All Stainless Steel Construction IP65 Housing Wide Operating Temperature Range Low Static and Thermal Errors , EMI/RFI Protection Compatible with Wide Range of Liquids and gases -40 to 85 C Operating Temperature , Accuracy:

Wide temperature range: -40C to 1030C, Response time: 25 ms Optical Resolution 15:1, Green LED alarm indication, aiming support, self-diagnostic Ambient temperature rating up to 80C without cooling, Scalable analog output: 0-10 V or 0-5 V + alarm output or digital output USB programming interface, direct serial 9.6 kBaud interface, Wide power range 5-7, 12-28 V DC

Accurate glass temperature measurements on float glass lines, container glass machines, bulb manufacturing, automotive glass tempering lines and the production of solar panels in the range of 100C up to 1650C Double laser aiming marks location and exact spot size at any distance High resolution optics with 1mm spot size Optics 70:1 or 45:1 with selectable focus, compact sensor head size Usable up to 85C ambient temperature without cooling and automatic laser switch off at 50C Cooling and protection accessories for harsh environmental conditions