Nozzle heaters are hermetically sealed for liquid plastic during the manufacturing process. The connection between the heating element and the leads is protected by a special fitting made of brass/stainless steel 1 mm thick, without welding which...
Anupam's Coil Type Nozzle Heaters are capable of performance under the most adverse conditions. Highly recommended for processing high temperature resins to eliminate premature failures due to burn out/ process material leakage. Heat transfer is...
APPLICATION Low cost electric heating of plastic processing, rubber vulcanizing, Drums, Barrels & cylinders etc. CONSTRUCTION Mica insulated Heaters consist of electric resistant ribbon / round wire element covered with zinc plated MS, Brass or SS...
Coil Type Nozzle Band Heaters are specially designed to prevent the failure of heaters against the leakage of plastic material at nozzle. These heaters gives higher temperature(above 250C) at nozzle point which is required for H.D. Plastics such as...
Sunrise Nozzle Band Heaters are available in Mica Ceramic tubular and sealed type Nozzle Band Heater are also available in-built thermocouple. We suggest micro tubular Nozzle Heater with brass busing and outer S.S. Trap for high temperature...
For Buyer 
For Seller 
Help 
