Nuts Bolts And Fasteners

Leading Manufacturer, Supplier & Retailer of Spring Cotter Pins, Ball Lock Pin, Stainless Steel Inserts, Tube Clamp Connectors and Tube Clamp Connector.

Spring Cotter Pins

Spring cotter pins Spring cotter pins GN 1024 are used for the axial fixing of bolts and axes and as distortion guard, e.g. for crown nuts DIN 935. Owing to their double winding, spring cotter pins of Type D have a flatter spring characteristic and are therefore easier to install. Also, a retaining rope inclding a key ring can be attached to the double winding to safeguard the spring cotter pins against loss.

View Complete Details

Ask Latest Price & Details

Ball Lock Pin

temperature up to 250 °C

Stainless Steel-Ball lock pins GN 113.3 are used for quick fixing, connecting and locking of various parts and workpieces. A typical application is locating pins which have often to be removed and installed again. By pressing the spring loaded push button both balls are unlocked and by releasing it the balls are locked again.Ball lock pins GN 113.3 are renowned for their compactness. The eye ring is enclosed unmounted.The load values given in the above table at shear stress are theoretically obtained and indicative only. They are non-binding recommended values and rule out any liability. They constitute no general warranty of quality and condition. The user must determine from case to case whether a product is suitable for the intended use.

View Complete Details

Ask Latest Price & Details

Stainless Steel Inserts

internal square ±0.5 mm

Drive the Stainless Steel-Insert bushes GN 992.5 in by using a soft-head mallet. Their lamellas bridge a production tolerance of the internal diameter or of the internal square of 0.5 mm, allowing screws to be mounted in tubes. The dimensions match those of the construction tubes GN 990, but checking the tolerance position of the tube is recommended

View Complete Details

Ask Latest Price & Details

Tube Clamp Connectors

Tube Clamp Connectors The clamping bores of GN 131 two-way connector clamps are mechanically machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462 respectively. The standard version of the clamping screws are socket cap screws with hexagonal socket DIN 912. They can be replaced by clamping kits GN 911 GN 911.3 (article code see table of dimensions).

View Complete Details

Ask Latest Price & Details