Titanium is as strong as steel but much less dense. It is therefore important as an alloying agent with many metals including aluminium, molybdenum and iron. These alloys are mainly used in aircraft, spacecraft and missiles because of their low...
Our Alloying Plant is capable of producing all kinds of Lead Alloys i.e. Antimonial, Calcium, Selenium, Copper, Tin, Arsenic etc. We have Alloying Kettles of various capacities ranging from 7-30 tones per batch. They are fitted with high efficiency...
We are engaged in manufacturing varieties of high quality aluminium alloys available in various chemical composition. These different alloys can be used for sand, gravity and die casting, which can then be utilized in construction industry,...
Assistance of warehouse management software helps in minimizing the efforts of the personnel and ensures the safe storage of the lot. Moreover, our experts keep a stringent check over the same. Keen on procurement of Gun Metal? We are one of the...
Gunmetal alloys consist of the most commonly used bearing materials. They rank somewhat lower than unleaded or leaded copper tin alloys in load caring capacity. However they adequately satisfy requirements for bearings operating in the moderate...
Pioloform ®  coated grids without a carbon layer are suitable for TEM applications up to 100kV. Pioloform is sometimes preferred to Formvar® because of its higher mechanical and thermal stability, and lower bulk which can help reduce electron...
Holey carbon films have many uses in microscopy but for certain applications the mesh sizes of standard TEM grids are too large to support the sample. Continuous carbon films can also be a problem due to the fact that the thin film can inelastically...
These thin cast films of Formvar have been strengthened with the addition of a layer of evaporated carbon on nickel grids. The composite films have extra resilience and strength compared with carbon films. They are recommended for use where the grid...
For Buyer 
For Seller 
Help 
