Our Products
We are leaders in the market for providing best range of Wire Tracer Kit and CABLE IDENTIFIER AND TESTER KIT
The TG20 Wire Tracer Kit identifies wire pairs, check continuity and test telephone line polarity. Transmitter has output cables terminated in modular RJ11 phone connector. The non-contact amplifier probe audibly identifies the selected wire or cable so that you can easily trace from source to termination. Comes complete with Wire Tracer Probe and Transmitter with RJ11 phone connector, a pair of alligator clips and two 9V batteries.
Features:
Transmitter with output cables terminated in modular RJ11 phone connector
Transmitter injects traceable signal into cables, checks telephone lines, and performs continuity checks
Non-Contact probe audibly identifies selected wire or cable
Easily trace wires from source to termination
Test for properly operating phone lines
Adjustable sensitivity control improves wire identification and eliminates false detection
Continuity test ? visible indication
Complete with Wire Tracer Probe and Transmitter with RJ11 phone connector and pair of alligator clips, and two 9V batteries
The CT40 enables one person to identify up to 16 local or installed lines. The built-in MultiMeter functions include: AC/DC Voltage and Current, Resistance, Diode, and Continuity for troubleshooting electrical/electronic circuits. Additional features are Data Hold and Max Hold, Auto Power Off and a low battery indicator on both the Transmitter and Receiver. CAT II-600 Volt safety rating. Comes complete with two 9 Volts batteries, 2 AAA batteries and a pouch case.
Features:
Troubleshoot electrical/electronic circuits and identify up to 16 local or installed lines
MultiMeter functions include: AC/DC Voltage and Current, Resistance, Diode, and Continuity
Transmitter/Receiver enables one person to remotely identify up to 16 wires
Wire voltage check from 5 to 16VDC
Data Hold and Max Hold, Auto power off
Low battery indicator (transmitter and receiver)
Complete with 16-line Transmitter, MultiMeter/Receiver, two 9V batteries, pouch case, and 2 AAA batteries