features of ndt 103 non destructive testing detects surface defects upto 1 micron width x 30 micron depth on standard ni - cr test panel. low halides and sulphate contents. non - corrosive and non - toxic. the quick opertional sequence makes results available immediately. convenient and easy to handle pressurised cans and bulk containers to suit various industrial needs. a general purpose, verstile and inexpensive technique. environment friendly cleaner spray- is an aerosol applied cleaner used as part of the ndt 103rack detection system for pre-use cleaning, also for the easy removal of rmc red dye and rmc developer sprays. cuts through dirt, grease and grime zero residue prepares surface for non destructive testing developer spray -is an aerosol applied white powder that is designed to draw the penetrant out of a flaw to enhance the definition. it is used to facilitate detection when used in conjunction with the ndt 103rack detection system. highly absorbent white film for rapid results highlights very fine cracks sharp indication and geometry of defect to the naked eye suitable for pressure testing & leak detection dye penetrant spray-dye penetrant is an aerosol applied dye which can be sprayed from any angle. used as part of the ndt 103rack detection system. bright red even film highly sensitive dye water washable application of ndt 103 non destructive testing non-destructive inspection system is designed to provide a fast reliable method for visual detection of cracks or flaws which would not normally be visible to the naked eye. ideal for the inspection of welded joints, castings, forgings etc. non-destructive testing kit includes the cleaner, penetrant and developer spray in a convenient carrypack. cleaner : stainless steel, titanium, nickel, carbides, ceramic and certain plastics, pressure, vessels, pipelines, heat exchangers, casting and forgings. developer :aluminum, magnesium, brass, copper, cast iron, steel, pipelines, heat, exchangers, casting and forgings, petrochemical plants, boilers. dye penetrant : pressure vessels, pipelines, heat exchangers, casting and forgings, petrochemical plants, boilers and others direction of use of ndt 103 non destructive testing shake well before use. clean the surface to removed dust with clean cloth. hold the can at least 8 to 12 cm from the surface you are spraying and keep the can upright during use. repeat the same every after every 8-10 operations. wipe off the spatter with a light cloth. when finished spraying, clean the aerosol valve by turning the can upside down and pressing the button until only propellant escapes precaution of ndt2 non destructive testing contents are extremely flammable and under pressure, do not puncture prevention : keep away from heat, sparks, open flames, hot surfaces. no smoking. avoid breathing dust, fume, gas, mist, vapours, spray. use only outdoors or in a well-ventilated area. do not contaminate water supply. incinerate or store above 50°c. exposure to high temperatures may cause can to burst. do not place in direct sunlight or near any heat source. aerosol cans will conduct electricity. keep away from all live electrical sources including battery terminals, solenoids, electrical panels and other electronic components. failure to observe this warning may result in serious injury from flash fire and/or electrical shock. first aid: swallowed – not considered a normal route of entry. do not induce vomiting. seek medical advice. avoid giving milk or oils. avoid giving alcohol. skin – flush skin and hair with running water (and soap if available). remove any adhering solids with industrial skin cleansing cream. do not use solvents. seek medical attention in the event of irritation.