Write a Review
Our Products
Our product range contains a wide range of Earth Rod, EARTH HAMMER and RIG and Earth Bonds
Quality earth rods are commonly made from either solid copper, stainless steel or copperbonded steel. Three types of earth rod are available, but the copperbonded steel cored rod is by far the most popular, due to its combination of strength, corrosion resistance and comparatively low cost.
Solid copper and stainless steel rods offer a very high level of corrosion resistance at the expense of lower strength and higher cost.
Diameter of rodOne common misconception is that the diameter of the rod has a drastic effect on lowering earth resistance. This is not true! As the graph shows, you only lower the resistance value by 9.5 per cent by doubling the diameter of the rod (which means increasing the weight and the cost of the rod by approximately 400 percent). Thus the rationale is: Use the most economical rod that soil conditions will allow you to drive. This is one of the ways to ensure that you dont waste money on over-dimensioned rods.
Thread and shank diametersConfusion often arises between thread and shank diameters for threaded rods. The thread rolling process, used by quality rod manufacturers, raises the surface of the rod so that thread diameter is greater than shank diameter. All threads are Unified National Coarse (UNC-2A).
Quality earth rods are commonly made from either solid copper, stainless steel or copperbonded steel. Three types of earth rod are available, but the copperbonded steel cored rod is by far the most popular, due to its combination of strength, corrosion resistance and comparatively low cost.
Solid copper and stainless steel rods offer a very high level of corrosion resistance at the expense of lower strength and higher cost.
Diameter of rodOne common misconception is that the diameter of the rod has a drastic effect on lowering earth resistance. This is not true! As the graph shows, you only lower the resistance value by 9.5 per cent by doubling the diameter of the rod (which means increasing the weight and the cost of the rod by approximately 400 percent). Thus the rationale is: Use the most economical rod that soil conditions will allow you to drive. This is one of the ways to ensure that you dont waste money on over-dimensioned rods.
Thread and shank diametersConfusion often arises between thread and shank diameters for threaded rods. The thread rolling process, used by quality rod manufacturers, raises the surface of the rod so that thread diameter is greater than shank diameter. All threads are Unified National Coarse (UNC-2A).
Where permanent connections are not appropriate, mechanical clamps offer the ideal solution. These are typically used on smaller scale installations where periodic disconnection for testing is required.
All mechanical clamps are manufactured from high copper content alloy. They have high mechanical strength, excellent corrosion resistance and conductivity.
Our range of earthing clamps are designed for connection of conductors to earth rods, reinforcing bars, steam pipes, handrails etc Manufactured to offer corrosion resistance, conductivity and mechanical strength, these are essential considerations in an earthing design to ensure an earthing system remains operative for many years.
All earth rod clamps have high strength copper alloy bodies and screws e.g. aluminium bronze, phosphor bronze etc., commercial brass is not used.
Shijina (ASWATHY CORPORATION)
107-110, Ashok Service Industrial Estate, L.B.S. Marg, Bhandup (West), Pin 400 078 MUMBAI, Maharashtra, Bhandup West - 400078
Share us via
