While rotating in anti-clockwise direction lower the ABSF tool into the bore.Give some clearance from the bore’s lower face and rotate in clockwise direction for wing to fold out.Lower the tool, rotate in anti clockwise direction for the wing to fold in and retract out of the...
Press the pivot pin in the bore, provided on the tool shank. Position the wing in the pocket through the pivot pin. Screw on the pivot screw through the tapped hole till its point enters the cone, provided in the bottom of the wing. Tighten the...
Make the axis of guiding pilot shank of the automatic rear counter boring tool true to the axis of the pilot hole. Use cotter / drive-key for preventing the tool from falling down while cutting. The back spot facing tool enters the pre-drilled pilot...
For Buyer 
For Seller 
Help 
