Output Current : 3 A maximum (Resistive load capability)
End-of-Line Resistor (EOLR-1): Not used/not required for this specific dry-contact relay module configuration. : Environmental Limits: Operating temperature range of 32°F to 120°F (0°C to 49°C) with 10% to 93% non-condensing humidity
Input Voltage: 15 to 32 VDC (Normal operating range provided by the SLC loop) : Output Voltage: 30 VDC (Maximum voltage rating for DC resistive loads across the contacts)
Brand Name : Honeywell
Color : Grey
Supply Type : Loop-powered. The internal circuitry and relay draw power directly from the two-wire Signaling Line
Mounting : Direct mount onto a standard 4-inch square electrical junction box (minimum depth of 2-1/8 inches
Input Voltage : 15 to 32 VDC (Normal operating range provided by the SLC loop)
Output Voltage : 30 VDC (Maximum voltage rating for DC resistive loads across the contacts)
Current Consumption: 6.5 mA maximum when the LED is latched steady red; 230 µA average during direct polling. : Protocol Support: Compatible with FlashScan (supports addresses 01–159) and CLIP (supports addresses 01–99) loop modes.
Size: 75mm (length) x 55mm (w) x 19.3mm (height) Weight: 58g Pcb color: blue board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed 4-channel relay control board module with an optocoupler, 4-way relay module for...
This is a 2 Channel 5V Relay interface board, Be able to control various appliances, and other equipments with large current. It can be controlled directly by Microcontroller(Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic)This is a 2...
4-channel relay control board module with optocoupler, 4 way relay module for arduino 4-channel relay output modules, relay output contacts 250A 10A. Input IN1, IN2, IN3, IN4, the signal line LOW effective. VCC, GND power input, can relay a separate...
Input Voltage : 15 to 32 VDC (Normal operating range provided by the SLC loop)
Brand Name : Honeywell
Input Voltage: 15 to 32 VDC (Normal operating range provided by the SLC loop) : Output Voltage: 30 VDC (Maximum voltage rating for DC resistive loads across the contacts)
End-of-Line Resistor (EOLR-1): Not used/not required for this specific dry-contact relay module configuration. : Environmental Limits: Operating temperature range of 32°F to 120°F (0°C to 49°C) with 10% to 93% non-condensing humidity
Supply Type : Loop-powered. The internal circuitry and relay draw power directly from the two-wire Signaling Line
OUTPUT CHANNEL : (DPDT configuration) that switch simultaneously. These are unsupervised, voltage-free contacts.
Output Voltage : 30 VDC (Maximum voltage rating for DC resistive loads across the contacts)
Mounting : Direct mount onto a standard 4-inch square electrical junction box (minimum depth of 2-1/8 inches
Size: 75mm (length) x 55mm (w) x 19.3mm (height) Weight: 58g Pcb color: blue board four weeks with four screw holes, hole diameter 3.1mm, easy to install and fixed 4-channel relay control board module with an optocoupler, 4-way relay module for...
4-channel relay control board module with optocoupler, 4 way relay module for arduino 4-channel relay output modules, relay output contacts 250A 10A. Input IN1, IN2, IN3, IN4, the signal line LOW effective. VCC, GND power input, can relay a separate...